Zusi-Forum

Hello all,

Yesterday I played "DLr 75885" on the Marschbahn. At Sbk 22 is Hp0+Zs1, so I cross it with befehltaste then accelerate to the fplgeschwindigkeit. In the end, I got a 20% overspeeding result. I don't know where i am wrong, maybe I should wait for the whole train to pass the signal before accelerate?

ZK6120CHEVG1 hat geschrieben: ↑01.11.2021 13:03:23 [...]
maybe I should wait for the whole train to pass the signal before accelerate?

Hi,
that's the exact way to solve your problem.
Higher speeds at signals or other signs signalling an increase in speed in general only are valid after the whole train did pass them.

Regards,
Thomas

EDIT: I have to apologize. Of course this does not hold for Blocksignals. Thanks, F.Schn. for the remark.

...except of block signals. At block signals you can increase your speed after the head of the train passed the signal.
Did you have a look at the graph page of the result?

F. Schn. hat geschrieben: ↑01.11.2021 16:19:45 ...except of block signals. At block signals you can increase your speed after the head of the train passed the signal.
Did you have a look at the graph page of the result?

Yep, it shows HG40 about 300m after the signal, but zuglänge is 257m

You did nothing wrong, you found a bug. See viewtopic.php?f=66&t=17718

SörenG hat geschrieben: ↑01.11.2021 21:35:57 You did nothing wrong, you found a bug. See viewtopic.php?f=66&t=17718

OK thx! But I didn't found any update about this problem. PS I'm in Steam version

But it depends on the year, in western Germany you originally had to go with 40 km/h until the complete train had passed the signal.

Carsten