control configuration

Hey folks, everyone speaking English may write in this category!
Antworten
Nachricht
Autor
VMPP
Beiträge: 48
Registriert: 17.02.2020 19:18:50

control configuration

#1 Beitrag von VMPP »

Hi

I want to use my x56 throttle as the combined brake-throttle.
I can configure the axes almost ok.
However, i would to have the range of travel divided into something like 75%-25% throttle-brake.

How do i configure the axis to have that kind of travel. I've played with the characteristc curve but can't quite get it...

Also, i have the AFb on one of the sliders, so it reads max at the min position. How do I reverse the axis?
And last, how do I use the axis 100% to one side? I have the dynamic on the other slider, but i only get half travel...

Benutzeravatar
Carsten Hölscher
Administrator
Beiträge: 33384
Registriert: 04.07.2002 00:14:42
Wohnort: Braunschweig
Kontaktdaten:

Re: control configuration

#2 Beitrag von Carsten Hölscher »

In the calibration window there are three buttons to mark the highest, lowest and the neutral position of the lever. See documentation as well.

Carsten

Antworten