Zusi-Forum
https://forum.zusi.de/

Train Editor: Adding signals following change of direction
https://forum.zusi.de/viewtopic.php?f=76&t=15932
Seite 1 von 1

Autor:  nextgenlemon [ 07.01.2020 23:30:59 ]
Betreff des Beitrags:  Train Editor: Adding signals following change of direction

Greetings!

I was wondering, whether any of you know a little trick in order to insert signals after a reversal?

So far I have been editing the .trn files to achieve this by adding W434 manually, then in the editor continue from there.

In this case, would there be any possible way of adding W434 within the editor?

If not, I'll shoot a little suggestion if I may. The ability to "force" a specific signal that you know the name of, into the "signals"-box underneath. This would make it so much easier :D

Thanks

Bild

Autor:  F. Schn. [ 08.01.2020 18:54:21 ]
Betreff des Beitrags:  Re: Train Editor: Adding signals following change of directi

There is no real solution. The timetable editor tries to think to much and this does not work on train reversal.

You can change the spawn point at the first page and later change it back. Or use a text editor to edit the trains.

Seite 1 von 1 Alle Zeiten sind UTC + 1 Stunde [ Sommerzeit ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/