Train Editor: Adding signals following change of direction
Verfasst: 07.01.2020 22:30:59
Greetings!
I was wondering, whether any of you know a little trick in order to insert signals after a reversal?
So far I have been editing the .trn files to achieve this by adding W434 manually, then in the editor continue from there.
In this case, would there be any possible way of adding W434 within the editor?
If not, I'll shoot a little suggestion if I may. The ability to "force" a specific signal that you know the name of, into the "signals"-box underneath. This would make it so much easier
Thanks
I was wondering, whether any of you know a little trick in order to insert signals after a reversal?
So far I have been editing the .trn files to achieve this by adding W434 manually, then in the editor continue from there.
In this case, would there be any possible way of adding W434 within the editor?
If not, I'll shoot a little suggestion if I may. The ability to "force" a specific signal that you know the name of, into the "signals"-box underneath. This would make it so much easier
Thanks