Train Editor: Adding signals following change of direction

Hey folks, everyone speaking English may write in this category!
Antworten
Nachricht
Autor
nextgenlemon
Beiträge: 6
Registriert: 05.09.2019 21:32:55

Train Editor: Adding signals following change of direction

#1 Beitrag von nextgenlemon »

Greetings!

I was wondering, whether any of you know a little trick in order to insert signals after a reversal?

So far I have been editing the .trn files to achieve this by adding W434 manually, then in the editor continue from there.

In this case, would there be any possible way of adding W434 within the editor?

If not, I'll shoot a little suggestion if I may. The ability to "force" a specific signal that you know the name of, into the "signals"-box underneath. This would make it so much easier :D

Thanks

Bild

F. Schn.
Beiträge: 4793
Registriert: 24.10.2011 18:58:26

Re: Train Editor: Adding signals following change of directi

#2 Beitrag von F. Schn. »

There is no real solution. The timetable editor tries to think to much and this does not work on train reversal.

You can change the spawn point at the first page and later change it back. Or use a text editor to edit the trains.

Antworten