Door side switch
Verfasst: 30.11.2018 11:52:07
Hi.
Once again, a question arises with the program.
I'm trying to set up a 4-position switch to select the doors on my desk. Seeing that there are no 4 positions to configure, as it has the selector of the 146, I have decided to modify the switch and I have installed a potentiometer to work as an axis, such as traction and braking levers.
Zusi3 recognizes it and allows me to calibrate it and assign it to the door selector, but when I try to test it in the simulator, it does not do anything.
I have been testing in various ways and I do not know how to continue.
Could you help me with this topic?
Thank you so much again for your help.
regards
Once again, a question arises with the program.
I'm trying to set up a 4-position switch to select the doors on my desk. Seeing that there are no 4 positions to configure, as it has the selector of the 146, I have decided to modify the switch and I have installed a potentiometer to work as an axis, such as traction and braking levers.
Zusi3 recognizes it and allows me to calibrate it and assign it to the door selector, but when I try to test it in the simulator, it does not do anything.
I have been testing in various ways and I do not know how to continue.
Could you help me with this topic?
Thank you so much again for your help.
regards