Zusi-Forum

I am sure I am being a bit silly but I still can not set up my Raildriver correctly, for some reason it does not configure properly so that the levers do not do what I want them to do, the switches are ok it is just the levers.
I have gone into the configure page and clicked the corrosponding top/middle and bottom buttons but no matter what I try no luck when it comes to driving trains.
If anyone has a Raildriver and has got the levers working correctly perhaps you could kindly share your "P.I.-Raildriver.raildriver.xml" file?

Thanks

Did you try in the demo? There was (is?) a bug, that required a workaround.

Carsten

Carsten Hölscher hat geschrieben:Did you try in the demo? There was (is?) a bug, that required a workaround.

Yes Carsten have tried Demo and could not get it working in that either.

Not to worry, I am happy using keyboard.

That is fixed in the latest full version. The workarounf can be found somewhere in the german section of this forum. Sorry, I am busy at the moment.
Carsten

Hello,
in the demo you have to save the configuration at

C:\Users\Public\Documents\Zusi3Demo\_setup\input\P.I.-Raildriver.raildriver.xml

, before you leave the dialouge.
Regards
Stefan